CB-21

Current Sensing Mains Switcher
with in-built connecting block

When current is sensed on the main 3-pin plug, the internal relay switches on and supplies 240V to the 2nd 3-pin plug used to turn sources or external amplifiers on when the main system goes on.

OUTPUTS: One 240V control amplifier
One 240V switched (relay 20A)
One 12V switched for status
One 12V switched (40mA)
SIZE: 260 x 65 x 100 mm (WHD)

CB-26

Voltage Sensing Mains Switcher
with in-built connecting block

When 12V is sensed from the 2-pin connector on the side of the unit, the internal relay switches on, thus providing 240V to the 3-pin plug on top. Turns on source components using a 12V trigger instead of power cable.

INPUTS: Switching 5 to 15V DC
POWER: 240V 10 Amps
OUTPUTS: One switched 240V (10A)
SIZE: 260 x 65 x 100 mm (WHD

CB-27

Infrared Controlled Mains Switcher
with in-built connecting block

An IN-8 infrared encoder is required to learn on and off commands into a learning remote. When the CB-27 receives this IR command, the unit switches on and off accordingly.

IR CODES: Switchable to 8 IR codes
OUTPUTS: One 240V switched (10A)
One 12V switched (40mA)
SIZE: 260 x 65 x 100 mm (WHD)

IN-8 programmer required, see infrared

CB-28

Projection Screen Trigger
with in-built connecting block

In the off state, 240V is supplied to the UP pin on the 4-pin plug. When the CB-28 senses current on the 3-pin plug, the internal relay switches on and 240V is supplied to the DOWN pin on the 4-pin plug. Used to drop screen or lower/ raise lift when projector is turned on.

OUTPUTS: One 240V control amplifier
One 240V 4 pin switched
Three IR emitter ports
SIZE: 350 x 65 x 100 mm (WHD)

IRE-110

Single Emitter

3m cable
3.5mm plug
Emitter covers included

IRE-120

Dual Emitter

3m cable
3.5mm plug
Emitter covers included